GE Appliances · Dishwasher · 13 code records
Search this source-linked list using the exact display. Open a matching record for its plain-language meaning and manufacturer reference, then confirm the interpretation in your model manual.
Dishwasher codes can concern water entering, leaving, or being detected where it should not be. Similar labels can mean different things across makers, so match the manufacturer and model before using any instructions. The article scope may not cover every GE Appliances dishwasher model or revision.
999Possible leak-detection alert on GE models with Floor Protect; GE notes the meaning can differ on other models.
If water is present or a leak warning is active, stop and contact GE. The code is not proof that the floor is dry.
C1GE says the pump-out during drain exceeded two minutes.
GE notes not all fault codes appear on all models. Use the exact dishwasher manual and contact service if it persists.
C2GE says the total pump-out cycle exceeded seven minutes.
This is a model-specific dishwasher fault. A general lookup cannot determine whether a drain part has failed.
C3GE says the dishwasher will not drain.
If water remains, use the exact owner manual and stop if water is near electrical components.
C4GE lists several possible contexts, including a repeated fill after power loss or a float/drain condition.
The broad definition is model-specific and not a diagnosis of a single component.
C5GE says the pump-out time is too short, with water supply among the listed checks.
Use GE's model-specific support page for owner-level steps; stop if a leak is visible.
C6GE says incoming water temperature is too low for the dishwasher's expected operation.
The fault code does not justify changing water-heater settings without the exact appliance guidance.
C7GE says the dishwasher water-temperature sensor circuit is inoperative.
This is an electronic service condition; do not open the control or probe wiring.
C8GE says the detergent cup is blocked from opening fully.
The dispenser design is model-specific; check the owner's manual for the exact unit.
F56Failure to drain in GE's dishwasher fault-code table.
GE points to drain-path guidance; do not pull a built-in dishwasher without the installation manual.
FTDFailure to drain in GE's dishwasher fault-code table.
GE points to drain-path guidance; do not pull a built-in dishwasher without the installation manual.
H2OLow-water condition in GE's dishwasher code table.
Not all models use the same code. Check the model number and manufacturer manual.
PrSGE says the pressure sensor is sending an invalid signal.
GE recommends service for this fault. The code is not a consumer sensor-repair instruction.
No matching code in this manufacturer article set. Check the exact display on the official support site.
Before you act
Dishwashers: A leak or water-protection warning can involve hidden water near electrical parts. Do not pull the unit from cabinetry, remove panels, or run another cycle to locate a leak.
These summaries describe the manufacturer's published explanation. They are not a remote diagnosis and do not establish that a specific component has failed.